North Carolina NCDMV CDL General Knowledge Practice Test 3
Test 3 of 5. Pick an answer for each question to see if it is right and why; your score appears at the end. You need 40 correct answers to pass, the same ratio as the real North Carolina test.
- Questions50
- Correct to pass40
- Passing score80%
- Minimum age18 years
-
1. You pick up a sealed trailer at a shipper. What should you check before leaving the dock?
Show answer
Answer B: That the seal number matches the paperwork and that the doors are properly closed
You cannot look at a sealed load, but you can confirm that the seal is intact, that its number matches the documents and that the doors are secure.
-
2. What tells you that an air suspension bag has a problem?
Show answer
Answer B: The bag is leaking or damaged, or the vehicle sits unevenly on that side
An air bag that leaks or is cut lets that corner of the vehicle settle, which throws the load onto the other suspension parts and changes the ride height.
-
3. What is a bulkhead in a cargo body used for?
Show answer
Answer D: To divide the space and stop cargo from moving into another part of the body
A bulkhead is a solid partition that separates one part of the load space from another and blocks the cargo from moving past it.
-
4. A strap runs from an anchor point on one side of the trailer, over the load, and down to an anchor point on the opposite side. How much of its working load limit counts toward the total required?
Show answer
Answer C: All of it
A tiedown that is anchored on one side, passes over or around the cargo and is anchored on the other side counts its full working load limit toward the aggregate figure.
-
5. You are not certain that your loaded vehicle will clear a low overpass. What should you do?
Show answer
Answer A: Take another route rather than risk it
There is no safe way to guess at a clearance, and striking a bridge endangers everyone on and under it, so the only correct choice is a different route.
-
6. You must drive well below the speed of surrounding traffic, for example when climbing a steep grade with a heavy load. What should you do?
Show answer
Answer B: Turn on the four-way flashers to warn following traffic, where state law allows it
Flashers warn faster traffic that a slow-moving vehicle is ahead, which helps prevent rear-end crashes; some states restrict their use while moving, so check the local rule.
-
7. How is a shipping container normally secured when it is carried on a special container chassis?
Show answer
Answer B: With its own locking devices that attach the container directly to the chassis frame
Containers built for rail or ship transport have locking corners that fasten to a matching chassis; a container carried on a plain flatbed must be secured like any other cargo.
-
8. You have just passed another vehicle on a two lane road. What tells you it is safe to return to your lane?
Show answer
Answer B: You can see the whole front of that vehicle in your right mirror
Seeing the entire front of the vehicle you passed in your mirror proves you are far enough ahead to move back over without cutting the driver off.
-
9. What is the payload of a truck?
Show answer
Answer C: The weight of the cargo the vehicle is carrying, that is the loaded weight less the empty weight
Payload is what is left of the legal or rated weight once the weight of the empty vehicle is taken off, and it is the weight of cargo that can be carried.
-
10. What should a driver assume about the height posted at a bridge or an overpass?
Show answer
Answer B: That it may be wrong, because repaving or packed snow can leave less clearance than the sign shows
Resurfacing and packed snow raise the road under the structure, so the real clearance can be lower than the posted figure.
-
11. A strap is a little too long, so a driver ties a knot in it to take up the slack. Is that acceptable?
Show answer
Answer C: No, tiedowns must not contain knots
A knot destroys the rated strength of a tiedown, so the rules do not allow knotted securement devices; the excess is taken up by the winch or ratchet instead.
-
12. Why should a driver avoid shifting gears in the middle of a turn at an intersection?
Show answer
Answer D: Shifting during the turn takes a hand off the wheel and can cost you control
Pick the gear before you begin turning; shifting in the turn removes a hand from the wheel and can interrupt power just when you need steady control.
-
13. Why does a driver use pull-ups while backing into a tight space?
Show answer
Answer C: To pull forward and start the approach again when the angle is going wrong
Stopping, pulling ahead and repositioning fixes a bad angle safely, and there is nothing wrong with needing more than one attempt.
-
14. Which North Carolina CDL endorsements require a skills test in addition to a knowledge test?
Show answer
Answer B: The P passenger endorsement and the S school bus endorsement
NCDMV requires a skills test for the P passenger and S school bus endorsements, while H, N, T and X are added on a knowledge test alone.
-
15. You are driving past a park where children are playing close to the curb. What is the correct assumption?
Show answer
Answer A: A child may run into the street without looking
Children act on impulse and do not judge traffic well, so a driver has to expect one to enter the road and slow down in advance.
-
16. What are you checking on the mud flaps during the walkaround?
Show answer
Answer C: That they are securely attached, not torn and not dragging on the ground
A flap that is torn or hanging loose stops shielding following traffic from spray and stones, and a dragging flap can catch and tear away on the road.
-
17. A 60 foot combination traveling above 40 mph should hold how many seconds of following distance?
Show answer
Answer D: Seven seconds
Six seconds cover the 60 feet of vehicle length, and one extra second is added because the speed is above 40 mph.
-
18. Which items belong to the trailer part of the walkaround inspection?
Show answer
Answer D: Landing gear, doors, tires, wheels, lights, reflectors, frame and cargo securement
The trailer has its own running gear, lighting, structure and load, and all of it is the responsibility of the driver pulling it.
-
19. What is the minimum tread depth for tires in positions other than the steering axle?
Show answer
Answer A: 2/32 inch
Drive and trailer tires must keep at least 2/32 inch of tread in a major groove, measured away from tie bars and fillets.
-
20. Why must exhaust components be checked for contact with other parts of the vehicle?
Show answer
Answer B: Hot exhaust parts touching fuel lines, tires or wiring can start a fire
Exhaust pipes run hot enough to ignite fuel and melt insulation, so they must be kept clear of the fuel system, the tires and the electrical harness.
-
21. What happens to braking distance when speed is doubled?
Show answer
Answer C: It becomes about four times longer
Braking distance grows with the square of speed, so doubling the speed multiplies both the braking distance and the force of an impact by about four.
-
22. You are about to back across a quiet street into a driveway. Which of these is good practice before you start to move?
Show answer
Answer B: Turn on the four-way flashers and sound the horn to alert anyone nearby
Warning other road users and pedestrians before a reverse maneuver gives them the chance to stop or move clear before the vehicle starts back.
-
23. When a helper guides you while backing, what should be agreed on before you start?
Show answer
Answer D: A set of hand signals, especially the signal that means stop
The driver and helper must agree on signals in advance, above all the stop signal, because they usually cannot hear each other.
-
24. What is the correct order for a double clutch downshift?
Show answer
Answer D: Release the accelerator and push the clutch to reach neutral, release the clutch and press the accelerator to raise engine speed, then push the clutch again and select the lower gear
A lower gear turns faster than the one being left, so engine speed has to be raised in neutral before that gear will engage cleanly.
-
25. What is the correct order for a basic double clutch upshift?
Show answer
Answer B: Release the accelerator and push the clutch, shift to neutral, release the clutch, let engine speed drop, push the clutch again and shift to the higher gear
Double clutching passes through neutral with the clutch released so engine speed can drop to match the next gear before it is engaged.
-
26. How should a commercial driver treat the speed posted for a curve?
Show answer
Answer B: As a limit set for cars in good conditions, so a heavy or tall load calls for a lower speed
Posted curve speeds are based on passenger vehicles in good conditions, and a tall or heavy load can roll over well below that speed.
-
27. What does safe practice require of a commercial driver who wants to eat, drink or read a delivery note?
Show answer
Answer B: Handle it before or after driving, not while moving
Anything that takes hands, eyes or attention away from the task belongs outside the driving time, not inside it.
-
28. The temperature is around freezing and the road looks wet. What is a practical way to tell whether it is icy?
Show answer
Answer C: Check for ice building up on the mirrors, antenna or the front of the vehicle
Ice that forms on the mirror, antenna or windshield is a warning that the road surface is freezing too, and black ice can look like a wet road.
-
29. What must the driver check about the seat belt during the inspection?
Show answer
Answer A: That it is securely mounted, adjusts properly and is not ripped or frayed
A belt only restrains the driver if its anchorage is sound and the webbing is intact, so mounting and condition are both checked.
-
30. What is the coupling device weight rating on a vehicle?
Show answer
Answer A: The most weight that the coupling on the vehicle is rated to pull
The coupling device rating is a limit on how much weight the coupling may tow, and it is one of the ratings that has to be respected when a combination is loaded.
-
31. You want to check whether a tire on your truck is properly inflated. What is the correct method?
Show answer
Answer A: Measure the pressure with a tire gauge
Only a tire gauge tells you the actual pressure; a tire can look and sound normal while being badly underinflated.
-
32. Your axle weights are legal, but the tires on that axle are rated below the weight it is carrying. What controls?
Show answer
Answer B: The lower figure, so the tires may not be loaded beyond their marked rating
You may never exceed the rating marked on a tire, even when the axle limit would allow more, because an overloaded tire builds heat and can fail.
-
33. During the walkaround inspection, where does the driver normally start and how does the check proceed?
Show answer
Answer C: At the left front of the vehicle, working around it in a set order that returns to the cab
The walkaround follows the same route every time, starting at the left front and circling the vehicle, so that nothing is skipped when the driver is tired or rushed.
-
34. At 55 mph on dry pavement with good brakes, total stopping distance for a loaded heavy vehicle is roughly what?
Show answer
Answer B: About 400 feet or more
Perception, reaction, and braking together add up to roughly 400 feet or more, farther than the length of a football field.
-
35. What is the correct way to test the parking brake before a trip?
Show answer
Answer C: With the parking brake set, put the vehicle in a low gear and gently try to move forward
A parking brake that holds against a gentle pull in low gear is working; if the vehicle moves, the brake needs adjustment or repair.
-
36. What should be done before a night trip to get the most from your headlights?
Show answer
Answer C: Clean the windshield, the mirrors and the lights
Dirt on glass and lenses cuts both the light you throw down the road and the light that reaches your eyes, so cleaning is the cheapest night safety measure there is.
-
37. You are stopped in a line of traffic behind a car. How much space should you leave in front of you?
Show answer
Answer C: Enough to see where the rear tires of that car meet the road
That amount of space lets you pull around the vehicle ahead if it stalls and absorbs some of the shock if you are struck from behind.
-
38. An empty van trailer cleared a low overpass on the way in, but on the way back it is loaded. Which statement is true?
Show answer
Answer C: An empty van rides higher than a loaded one, so it needs more clearance than when loaded
Springs compress under load, so an empty trailer is taller; the unloaded trip is the one that can catch a low overhead.
-
39. You need to check your route on a navigation device. What is the correct approach?
Show answer
Answer D: Set it before the trip or after you have parked
Route programming is planning work, and it belongs to the time before the wheels turn or after the vehicle is safely parked off the roadway.
-
40. How many attempts at a given North Carolina CDL knowledge test are allowed in one day?
Show answer
Answer D: One
NCDMV allows only one attempt at each CDL knowledge test per day, and after three unsuccessful attempts at the general knowledge test another application fee buys three more attempts.
-
41. What is the purpose of an escape ramp on a mountain grade?
Show answer
Answer C: To stop a runaway vehicle without injuring the driver
Escape ramps use soft material or a steep upgrade to bring a vehicle with failed brakes to a controlled stop.
-
42. Why should high beams not be used in fog?
Show answer
Answer A: The light reflects back off the droplets and blinds you
Fog is made of water droplets that scatter light straight back at the driver, so a stronger beam makes the wall of glare worse rather than better.
-
43. Which components on a typical engine are driven by belts that must be checked for wear and tension?
Show answer
Answer D: The alternator, the water pump and, on many vehicles, the air compressor
Belts drive accessories such as the alternator, the water pump and the air compressor, so one failed belt can take out charging, cooling or air supply.
-
44. A driver snores heavily, stops breathing briefly during the night and is tired all day despite long hours in bed. What should be suspected?
Show answer
Answer B: Sleep apnea
Sleep apnea repeatedly interrupts breathing during sleep, so the driver never gets true rest and stays dangerously drowsy during the day.
-
45. You are backing with a helper guiding you and the helper drops out of sight in your mirror. What should you do?
Show answer
Answer B: Stop until you can see the helper again
If you cannot see the helper you cannot receive a signal to stop, so the only safe action is to halt until visual contact is restored.
-
46. On a one way street or a divided highway, where are the warning devices placed?
Show answer
Answer B: About 10 feet, 100 feet and 200 feet back toward the approaching traffic
When traffic can only come from one side, all three devices are spread out behind the vehicle to give approaching drivers a longer warning.
-
47. Which lamp must make the rear registration plate legible after dark?
Show answer
Answer C: A white lamp that lights the plate
A white license plate lamp is required so the plate can be read at night, and a burned out one is a defect like any other lamp.
-
48. A dock crew loads all of the freight at the very back of a 48 foot van trailer. What are the two consequences?
Show answer
Answer A: The steering axle is relieved of weight and steering becomes light, and the trailer axles may go over the limit
Weight placed far to the rear lifts weight off the front of the combination, so the steering goes light while the trailer axles take too much of the load.
-
49. On a scale, your loaded truck is well under the gross weight limit, but one axle is above the limit for that axle. What does this mean?
Show answer
Answer D: The vehicle is overloaded and the load must be shifted or reduced before you drive on
Each axle and axle group has its own limit and each must be respected; being under the gross limit does not excuse an overloaded axle.
-
50. What does North Carolina law say about cell phone use by the operator of a school bus?
Show answer
Answer B: No use of a cell phone or other mobile technology at all
North Carolina bars any person from operating a school bus on a public street, highway or public vehicular area while using a cell phone or any other technology associated with a mobile device.